![]() ![]() Secondly, how are you powering the lot? And can your provide a link to the technical details of your motor shield? Is there a Void Setup code that I can try that is appropriate for the EtherMega setup? I have Googled it thoroughly and found nothing.Īlso, when I plugged the DC motor into the shield, I made sure to put it into Channel A to match the Void Setup code.įirst of all, try some code for Arduino Uno from your motor shield supplier. The RX and TX lights on the EtherMega controller hardly flash so I assume the Void setup code is the problem. However, when I try the same code with a Freetronics EtherMega controller board (based on Arduino Mega 2560 controller) and an Arduino 6 channel motor shield ( ), I get no movement on the motor at all. ![]() I copied the Void setup code into Arduino 1.0.5-r2 and the motor moved as expected. I can get the motor to move when using a Freetronics Eleven controller board (based on Arduino Uno controller) and the two channel Arduino motor shield. I was testing out my Arduino hardware using this link:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |